Mold making supplies - Any Interest

Kdog

Moderator
Joined
Apr 26, 2013
Messages
1,808
Location
SW Ohio
I followed the mold making thread for quite a while and am thinking about making a few molds.

Material 1.5 x 2 x 0.5 thick stock 6063 T-52 aluminum which for the molds I want will be more than adequate. Buying a small amount of material is cost prohibitive but if I buy a larger qty, cost will come down to 3.00 for each block or $6 for 2 blocks. So I thought I would make an offer and if there is enough interest. I will buy a 20' piece and cut it into 2" long paired blocks and sell to anyone interested. Shipping will be 6 dollars for up to 12 sets.

Let me know via PM if you are interested. I would need to buy enough material to make ~60 pairs and if I can get commitments for 40 pairs will go ahead and buy some stock.
 

Kdog

Moderator
Joined
Apr 26, 2013
Messages
1,808
Location
SW Ohio
It appears there is not much interest. Plateboater, If I can get a smaller drop at a reasonable price, I'll keep you in mind.
 
Back
Top