Airstreamfield
New member
- Joined
- Dec 8, 2014
- Messages
- 79
So I finally got the flutter jig mold I have been after, or one of them anyway...I started pouring the jigs and I have got a ton of bad pours.
I forgot to take any pictures but the lead only goes in the mold any random amounts 1/4 1/8 3/4 and it will have like bubbles in it. I tried adjusting the heat all the way until the pot got red hot, and then down a bit to lower than I usually run it but it seemed like I wasn't getting a very good pour and it was a bit thicker than I like it...I think that might have something to do with it.
I was wondering if you guys might know what my problem is...
Thanks!
I forgot to take any pictures but the lead only goes in the mold any random amounts 1/4 1/8 3/4 and it will have like bubbles in it. I tried adjusting the heat all the way until the pot got red hot, and then down a bit to lower than I usually run it but it seemed like I wasn't getting a very good pour and it was a bit thicker than I like it...I think that might have something to do with it.
I was wondering if you guys might know what my problem is...
Thanks!