Jig Packaging

toadfrog

Active member
Joined
Jun 28, 2010
Messages
2,811
Location
OKLAHOMA
This is the way I package jigs to keep them neat in a bag. I made this little skid to slide them in . I also use a skid to put plastics in bags . Once they are in squish all the air out of the bag and zip closed. If they don't undergo a lot of tossing around they will stay pretty much put .
 

Attachments

  • 20190207_135910.jpg
    20190207_135910.jpg
    177.2 KB · Views: 36
  • 20190207_140101.jpg
    20190207_140101.jpg
    196.8 KB · Views: 31
  • 20190207_140126.jpg
    20190207_140126.jpg
    180.8 KB · Views: 28
  • 20190207_140152.jpg
    20190207_140152.jpg
    179.1 KB · Views: 35

Hawnjigs

KISS
Joined
Mar 23, 2010
Messages
4,226
Location
Ogallala, NE
A project worth considering...what materials did you use for the skid and raised rails? Don't soft plastics stick to the skid?
 

toadfrog

Active member
Joined
Jun 28, 2010
Messages
2,811
Location
OKLAHOMA
I used a piece of plexi glass to make the skid . Polished of the sharp edges . Then bent a finger hold with a heat gun . Split some dowels to glue on for position rails. Now for plastics I just use a skid without rails . Because plastics will stick in the bag where you put them . I do keep the skid oiled down with worm oil or similar so the plastic will slide off. Use a little engraver to mark the skid on the back for each product . Don't use markers , worm oil and the like will take off the writing . Then it winds up on your product.
 
Back
Top